Flashing Your Vehicle with the AA/Dynojet PV3

AA PV3 Installation Video: https://www.youtube.com/watch?v=KK74Ed_Iw_o

See our video on flashing with your PV3. This is shown on a Polaris but is the same basic process for all vehicles. For Can Am models with push button start, you need to have your key fob installed, then tap the start button to power up the device and have ECU/tuner communication.

**Keep in mind if you have a Can Am or Wideband(blue o2 lead) Polaris model, you will not be able to do an ECU read. The Stock file is provided on the device.**

Diagnostic port locations

Polaris 2022+ Pro XP/Turbo R/Pro S: Black 6 pin connector with a purple locking clip. Diagnostic port is located under the dash. This would be near your right knee when sitting in the drivers seat.

Polaris 2016-2021 RZR Turbo/Turbo S: Black 6 pin connector with a purple locking clip. Under the front hood of the vehicle plugged into a dummy plug on the firewall.

Polaris RS1: Black 6 pin connector with a purple locking clip. Diagnostic port located under the dash near your knees if sitting in the drivers seat.

Polaris General 2016+, 2014-23 RZR XP 1000, RZR 900, RZR 1000 S/Trail: Black 6 pin connector with a purple locking clip. Diagnostic port is located under the front hood.

Polaris Ranger 900/1000 Models: Black 6 pin connector with a purple locking clip. Under the seat or rear seat near the battery. Remove the tray that is under the center seat (or center rear seat) and you will find the diagnostic connector.

Can Am X3: Square gray connector. On early models this was located in the glove box on the left hand side. Later models have this located in the upper fuse panel which is on top of the dash in the center of the vehicle.

Can Am Defender: Square gray Located under the front hood of the vehicle. Locate the diagnostic port near your brake fluid reservoir.

Can Am 2021+ Commander: Square grey connector located under the dash near your left knee if sitting in the drivers seat.

Kawasaki KRX & Ridge: Semi transparent plug located under the dash near your left knee if sitting in the drivers seat.

Kawasaki Teryx H2: Semi transparent plug located under the dash near your right knee if sitting in the drivers seat. If you have a model with the Garmin center display, you must disconnect this when using the PV3 to avoid dash lights and CAN interference. See HERE for how to disconnect.

Don’t see your vehicles diagnostic connector listed? Email us, or you can find vehicle specific instructions on dynojet’s website.