- AA Machined Venturi Nozzle for all Sea-Doo Switch models (100HP, 130HP, 170HP & 230HP)
- Also fits 300HP watercraft, & 325hp watercraft models (RXP-X, RXT-X, GTX, GTR-X)
- This machined nozzle is a great way to gain 100-200 RPM on Switch 230 models or 50-100 RPM on 300/325 HP watercraft models. The 2nd and 3rd acceleration graph show the change between the factory nozzle and AA machined nozzle – a .3 second drop in 17 less feet from 5-60 MPH.
- The stock nozzle has a very small end, and machining it allows for less load on the pump, so more RPM
- We suggest using this nozzle with our tuning or you may hit the OEM rev limit (most would not, but it's possible)
- Supercharged models (230HP/300HP/325HP) will benefit as extra RPM means the supercharger spins faster, creating more boost pressure resulting in quicker acceleration and more consistent top speeds
- 325 watercraft models with a tune should run high RPM right from the factory, so we'd NOT suggest this nozzle unless needing higher RPM for a specific reason, or to get RPM back up after going to a steeper pitch impeller.
- Naturally aspirated 100/130/170HP Switch models wont' benefit as much unless more RPM is needed. We found in most cases, the OEM nozzle size works best on the naturally aspirated models.
- Simply remove your OEM nozzle and install this one. Roughly 10-20 minute change.
- Comes ready to bolt on with venturi tubes installed and new O-rings
- Part Number: 112-1058
AA Machined Venturi Nozzle for Sea-Doo Switch (All HP Models) + 300/325 HP Watercraft
$195.00
AA Machined Venturi Nozzle for all Sea-Doo Switch models (100HP, 130HP, 170HP & 230HP) Also fits 300HP watercraft, & 325hp watercraft models (RXP-X, RXT-X, GTX, GTR-X) This machined nozzle is a great way to gain 100-200 RPM on Switch 230 models or 50-100 RPM on 300/325 HP watercraft models. The 2nd and 3rd acceleration
| Weight | 4.0 lbs |
|---|---|
| Dimensions | 10.0 × 10.0 × 10.0 in |